DarwinFPV TinyApe Freestyle - ELRS BNF

Tiny Ape Freestyle is the first 2.5'' drone for Darwinfpv. In order to meet the needs of more friends and we have made multiple attempts. It comes with the Darwin ELRS2.0 F411 15A Bluejay AIO and the VTX006 which has 25-600mW output power.

Drone Configuration:

• Weight: 50.3g (without batteries and paddles)
• Propeller: Gemfan 2512 3-blade propeller
• FC&ESC：F411 1-3S 15A FC(Built-in ELRS 2.4G receiver)
• Built-in Receiver Protocol: SPI ELRS 2.4G 
• Motor: 1103 8000KV Brushless Motor
• Camera: RunCam Nano 4
• VTX:25-600mW VTX
• AIO Firmware: betaflight_4.3.0_BETAFPVF4SX1280
• ESC Firmware: Bluejay_S_H_50_48_v0.14
• Recommended Battery: 2S 380-450mah
• The factory AIO firmware only supports ELRS_V2.0, and can be used with ELRS_V2.0 version TX

FPV Camer - RunCam Nano 4 Camera

The RunCam Nano 4 uses a 1/3'' CMOS sensor, 2.1mm lens and 800TVL resolution for better realistic color and clearer low-light night vision.

Brushless Motor - 1103 8000KV

1103 8000KV Brushless motor is only 3.7g and it’s power and thrust are surprising, and the flight time can achieve about 5 Minutes. We have notice: the motor only supports 2S batteries, and if it is connected to 3S to push the throttle too much, the motor will be permanently damaged .

Flight Time (Approximate) 5.25min Landing voltage 380mah (3S- 9.75V
Flight Time (Approximate)  5.18min - Landing voltage 450mah（2S- 6.5v

Video Transmitter - VTX

VTX006 has 25-600mW output power and can provide stable images and powerful transmission. You can choose the perfect output power according to you FPV requirements. ( The default setting of the output power for Tiny Ape is 400mW)

DarwinFPV VTX Quick User Guide - Red light flashing frequency

1 Flash 25mW
2 Flashes 200mW
3 Flashes 400mW (Default Setting)
4 Flashes 600mW

FPV Drone Flight Controller

This is an updated version of Darwin AIO. We integrated the ELRS receiver on the FC to make it easier to apply to mini drones. The ESC adopts Bluejay firmware, compatible with 1-3S Lipo input, 15A continuous current and 17A peak current. FC provides 2 sets of Uarts interfaces, and also provides various external device interfaces such as SBUS, Softserial, CTR, BUZZ, RGB, etc., which perfectly solves the problem of insufficient number of F411 Uarts.

The built-in receiver is an SPI protocol receiver, so you need to select SPI receiver support (SPI RX support) in the betaflight configurator. Under normal circumstances, the checkbox on the betaflight configurator receiver is empty. If the betaflight configurator used is 10.8.0 and above, the checkbox should select "EXPRESSLRS". As shown below: