3Amp UBEC with JST Connector
Details
3Amp BEC with JST Connectors (Plug and Play)
The U-BEC is an external circuit that taps power from your battery pack and regulates the voltage to the necessary 5 volts to power your receiver and servos. It does not replace the speed control. However, it replaces the BEC function in a speed control with much more capabilities.
The needs for a U-Bec are necessary when the speed controller does not have an onboard BEC or when the servo count will exceed the ESC's capability.
Installation is simple, just simply solder the leads to the input side of the Speed Controller at the battery connector. Then simply plug the output lead plugs into the receiver.
If using this UBEC with a Speed Controller that contains a onboard BEC, simply disable the BEC by pulling the red pin out of the servo lead on the speed control
- Output Voltages: 5.3V / 5A
- Weight: 15g
- Current Capability: 3A continuous
- Wire Length: 16cm
- Input Voltage 5v - 33v (2S -8S lipo)
More Information
Manufacture | Suppo |
---|
Reviews 4
- BECWorks excellent.
Posted on
- great and simlepart is easy to install
Posted on
- Ran testRan a test and it's output is good.
Has not been in use at this point. will mostly be used for receiver, servo and other on board system units bench work.Posted on
- Good BEC for the moneyGood BEC, easy to set up
Posted on