GH MicroJet V3 Brushless Outrunner Motor
Details
MicroJet V3 Parkjet SPEED 400 size Brushless Motor
After 4 yrs GraysonHobby and Welgard learned how to improve the original GH2212-06, by making it smaller and lighter a 3rd time. GraysonHobby was worked closely with Welgard for several months to develop a ‘V3 microjet’ which is a high speed high KV motor for smaller parkjets and parkflyers. Prop range is limited due to the High Kv (2200) rating of this motor. Use with 3 cell lipo battery capable of sustaining 20 amps. Prop range is from 5x5 to 6x4. Nearly as strong as the SuperSonic V2, but much lighter.
The motor features a 3.17mm hardened steel shaft, dual ball bearings, and has 3.5mm gold spring male connectors already attached and includes 3 female connectors for your speed control. Mounting holes have 16mm and 19mm spacing on centers and are tapped for 3mm (M3) screws. (ie if the mount does not fit, turn it 90 degrees)
Motor Stats
Li-Po Battery: 2 / 3 cells
RPM per volt : 2200
Poles: 14
No Load Current / 10V: 2.05A
Max Current: 30A/60 sec
Dimension: 27.5x26
Shaft: 3.17mm
Weight: 34g
Recommended Max Propeller: 6x4 See Chart below
Recommended Model Weight: 200 - 500g (7oz to 22oz)
More Information
| Manufacture | Suppo |
|---|
Reviews 6
- great goodas always good undamaged product.. fast shipping
Bench stock, not worried never had a bad motor from graysonPosted on
- F14 PARK JET GOES MICRO SONIC !This is the second GHMJV3 I've purchased. I cant say enough good about the motor. I put it on a FRC Foamies f14 that was 25 ounces AUW. I know I built it to heavy. While this motor is only rated for 20 ounces maximum thrust, it pushed the f14 around very well including loops , rolls and inverted flight. I bought this second MJV3 to put on a scratch build XB 70 Valkerie foamie I'm building . I highly reccomend this motor for any prop in the slot park jet with an all up weight of less than 20 ounces.
Posted on
- Great little motor, very reliableI use this motor in a 30 inch wing and it powers it well. unlimited vertical on a 3S 1300 MA battery with 5 min flight times.
Great !!!Posted on
- Awesome motors!Great motors for my scratch built jets and recently I have used them for my mini popwings with great results. A lot of power on 3 cell 1000mah - 1300mah batteries and the flight time is good too. Motors come down only warm.
Posted on
- G R E A TThese are little work horses. I use this with 1300mah / 3 cell, / over prop. with 7x5 prop on profile F-22. Fast, slow, all round fantastic 3d hook up. over prop. with throttle management , 1 year of "E" ticket rides (before it starts returning warm) I have had at least 10,over the years. 5 star
Posted on
- Great motor...just use a different escI've never had a problem with these motors until recently. The grayson hobby 30a esc cannot run this motor. It speeds up but makes a chirping sound every couple seconds. If you try and give it full thro, the esc will burn out. I had a few extra esc's and burnt one out. I've noticed the Mystery 30a esc always runs these motors well...not sure why Grayson would sell a motor /esc set that ultimately burns out the esc when you hook them up.
Posted on