INSTA-CURE PLUS
is a higher viscosity CA for loose fitting joints in which the adhesive must
bridge gaps.
Normally, the thicker CA is applied to one surface and then the
parts are held tightly together for about 5 to 15 seconds.
For large surface
areas, including those with close fitting joints such as laminations, INSTA-CURE
PLUS should also be used.
To prevent premature curing, DO NOT spread the glue into a
thin film. Lay down a serpentine bead with about 1" separations on one surface,
then assemble the parts, letting the pressure spread the CA out.
