Jumper R8 V2 16 Channel Receiver for Airplanes

89% of 100
Special Price $19.99 Regular Price $24.99
Out of stock
Jumper R8 V2 Updated Antenna 8CH PPM or 16CH Sbus - Receiver
More Information

Jumper R8 V2 Updated Antenna 8 Ch Fixed Wing Receiver

If you fly Fixed Wing Airplanes and went to jump into the open tx game, this receiver if should be your 1st choice. This Jumper R8 naturally works perfect with the Jumper T16 as well as any other transmitter which can bind to D8 or D16.  This receiver has more then enough range for the parkflyer and has 8 usable channels.  Works as any other fixed wing receiver, so setup is a breeze.


  • Number of channels: 8ch (PWM) / 16ch (SBUS)
  • RSSI (Signal Strength Indication) output: PWM
  • Operating voltage range: 4.0~8.4V
  • Operating current range: 100mA@5V
  • Effective distance: full distance (>2.0km)


  •     D8 mode
  •     D16 mode


  • More channels: 1-8 channels from traditional channel output, 1-16 channels from SBUS port
  • RSSI output: analog voltage output (03.3V)
  • Two-way full duplex transmission (Telemetry)
  • Weight: 10g
  • With RSSI output: analog voltage output (03.3V)

FailSafe Setup on the Jumper R8 Receiver

After Binding, set sticks and switches on radio and press the bind button again the R8

How to Bind
1. Press the bind button on the receiver, red/green LED solid on
2. On radio side, select Frsky D16 protocol (T12/T16: Multi Frsky D16);
3.When Red LED is flashing, binding succeeded.
4. After binding, withdraw the binding mode and power up the receiver again.  Green Led turns solid on.

 LED color description.
(The green light is always on: the signal is good; the green light is blinking: the signal is bad; the red light is always on: the signal is lost)

Jumper Manual R8Jumper R8 ReceiverJumper R8 V2

More Information
Write Your Own Review
You're reviewing:Jumper R8 V2 16 Channel Receiver for Airplanes
Your Rating
What's this? Check "Remember Me" to access your shopping cart on this computer even if you are not signed in.