Ultimate RC F22 Jet Fighter with Full Electronics

The HEE WING Hunter F22 is produced with MPP magic board, UV printing and laser cutting. With beautiful workmanship and exquisite appearance, this amazing RC airplane is made of lightweight and super durable material. It comes with brushless motor and ESC, providing powerful performance. This version comes with a flight controller that can self-stabilize flight control, achieve one-button takeoff and stable output for excellent performance. Assembley Required. 

• Material: PP Magic Board
• Wingspan: 400mm
• Length: 565mm
• Height: 130mm
• Motor: Brushless 1306 3700KV
• ESC: 12A
• Battery: 7.4V 500-800mAh Lipo
• Servos: 5G*2pcs
• Flight controller: FTC 2.1 version
• Propellant: 4045
• Weight (PNP): 95g
• Weight (take off): 135g
• Package Size: 430mm x 320mm x 50mm

Whats Included

1x HEE WING Hunter F22 400mm Wingspan RC Airplane KIT
1x 1306 3700KV motor
1x 5g Servo
1x 12A ESC
1x 4045 Propeller
1x flight controller
1x Nylon cable ties

Note: Battery, charger, transmitter, receiver, FPV devices and glue are not included.

Flight controller setup Notes:

 
functions of this plane need to learn step by
step.
1:Basic Settings for remote controls
Create a new model in your Transmitter .
Select the Airplane mode.
Set the fifth channel as the sc switch and
the seventh channel as the sb switch.
Set the throttle as reversal.
Check the setting of all channels.

 
2:Receiver's connecting and binding
First remove the propeller to avoid
accident during operation.
Connect the cable on the aircraft to the
s-bus of the receiver.Power on and check.

 
3:ESC calibration （Make sure the propeller is removed）
Turn on the transmitter and ture the switch to
competitive mode。
Turn off the safety mode and push the
throttle to the top.
Power on the aircraft and wait for the music
to end, Then push the throttle to the lowest
position quickly.Wait for the second music
to complete the calibration.

4:Calibration horizontal of plane
Turn on the transmitter and select the safety model.
Put the airplane on the ground and keep it on level.
Raise up the head of the aircraft about 60mm～80mm
and keep it face up.
Push the stick as video shown for three to four seconds and
release the stick after the rudder of the plane to jump once.
Completion attitude calibration