Radio Control Jet - Electric F22 Electronic Combo
- Buy 2 for $54.99 each and save 8%
Save $10.00 on the F22 ParkFlyer with Electronics
Details
The HEE WING Hunter F22 is produced with MPP magic board, UV printing and laser cutting. With beautiful workmanship and exquisite appearance, this amazing RC airplane is made of lightweight and super durable material. It comes with brushless motor and ESC, providing powerful performance. This version comes with a flight controller that can self-stabilize flight control, achieve one-button takeoff and stable output for excellent performance. Assembley Required.
- Material: PP Magic Board
- Wingspan: 400mm
- Length: 565mm
- Height: 130mm
- Motor: Brushless 1306 3700KV
- ESC: 12A
- Battery: 7.4V 500-800mAh Lipo
- Servos: 5G*2pcs
- Flight controller: FTC 2.1 version
- Propellant: 4045
- Weight (PNP): 95g
- Weight (take off): 135g
- Package Size: 430mm x 320mm x 50mm
Whats Included
1x HEE WING Hunter F22 400mm Wingspan RC Airplane KIT
1x 1306 3700KV motor
1x 5g Servo
1x 12A ESC
1x 4045 Propeller
1x flight controller
1x Nylon cable ties
Note: Battery, charger, transmitter, receiver, FPV devices and glue are not included.
Flight controller setup Notes:
functions of this plane need to learn step by
step.
1:Basic Settings for remote controls
Create a new model in your Transmitter .
Select the Airplane mode.
Set the fifth channel as the sc switch and
the seventh channel as the sb switch.
Set the throttle as reversal.
Check the setting of all channels.
2:Receiver's connecting and binding
First remove the propeller to avoid
accident during operation.
Connect the cable on the aircraft to the
s-bus of the receiver.Power on and check.
3:ESC calibration (Make sure the propeller is removed)
Turn on the transmitter and ture the switch to
competitive mode。
Turn off the safety mode and push the
throttle to the top.
Power on the aircraft and wait for the music
to end, Then push the throttle to the lowest
position quickly.Wait for the second music
to complete the calibration.
4:Calibration horizontal of plane
Turn on the transmitter and select the safety model.
Put the airplane on the ground and keep it on level.
Raise up the head of the aircraft about 60mm~80mm
and keep it face up.
Push the stick as video shown for three to four seconds and
release the stick after the rudder of the plane to jump once.
Completion attitude calibration
More Information
Manufacture | HeeWing |
---|
Reviews 1
- good quick but some reliability and instruction questionsThis model went together very easily with hot melt glue. See Buddy RC for a good video on this model. Note the ESC comes with an Xt60 connector and the batteries I ordered are JST. My ESC fried on the bench during initial powerup and checkout and I replaced it. The prop is not as advertised and is a 3.8x3. Controller has two modes. One mode limits the ESC to 70% power output. AUW was 140gms. Static thrust measured on the bench was close to 280gms. It looks like this model will really come alive with a 3S battery. A future test. The recommendation of the R81 receiver was a good one, although the wires are tough to solder on this one due to its tiny size. 2 flights so far. Flies well but it is a bit limited in the vertical. Rolls and loops are good. Great for a small park. Not for a new to the hobby customer IMO. My ranking would be 7/10.
Posted on