Surpass 3650 3100Kv Brushless Motor and 60A ESC Combo for Radio Control Car

Unleash the potential of your 1/10 touring cars and off-road RC vehicles like the Traxxas Slash 2wd with our powerful 3100Kv 3650 brushless motor combo. Paired with a compact 60Amp waterproof ESC, it's the ultimate upgrade for optimal performance. Perfect for 1/10 models or custom projects, this combo ensures maximum power for your RC adventures.

FEATURES
1. Water-proof and dust-proof for all-weather races; (Note: please uninstall the cooling fan before using this ESC in water;
Clean and dry it soon after the use for avoiding the connectors get rusty.)
2. Specially designed for C car with excellent start-up, acceleration and linearity features.
3. Compatible with sensorless brushless motor.
4. The strong resistant current capability, excellent heat dissipation.
5. Multiple protection features: Low voltage cut-off protection for lithium or nickel battery / Over-heat protection / Throttle
signal loss protection / Motor blocked protection/
6. Easily programmed and compatible with pocket-sized program card.

Sensorless Brushless Motor

Vehicle Size: 1/10

Watts: 900

Max Voltage: Less than 16V (3S Maximum)

Max Amps: 56A

Rotor Poles: 4

Max RPM: 50000

Length: 50mm

Diameter: 36mm

Weight: 180g

ShaftSize: 3.17mm

Length of Shaft: 15mm

Connectors on Motor: 4.00mm Gold 

60AMP ESC Specs

Continous Current: 60A Burst 360A

Battery 2-3S (4-9 cell NiMh)

BEC Output: 5.8v/3A (switch mode)

Dimensions 51.5mm x 38.5mm

Weight: 76g

For 2S Lipo or 6 cells NiMH:

• 1.on-road:3660-size or smaller motor
  with the KV<4300
• 2. Off-road / Buggy / Monster:3660-size
  or smaller motor with the KV<3300
•  

For 3S Lipo or 9 cells NiMH:

• 1. On-road:3660-size or smaller motor
  with the KV<3300
• 2. Off-road / Buggy / Monster:3660-size
  or smaller motor with the KV<2600.

Instuctions
1. Connect BEC wires with the receiver
2. Connect motor wires with ESC
3. Turn on the transmitter
4. Connect battery pack with ESC then switch on the ESC
5. When the connection of motor and battery is finished, the motor emits "Beep-Beep" tone.
6. When the throttle stick is in the neutral position, the motor re-emits "Beep-Beep" tone
7. The ESC is workable.

Troubleshooting
1. If after power on, motor can't work, no sound is emitted, please check the connections between battery pack and motor.
2. If after power on, LED flashes, please check the voltage of battery pack, which should be from 5V~13V.
3. If the motor emits a "Beep-Beep" tone Only, please check all the connections: BEC wires, transmitter and receiver, throttle
signal wires, etc. please check the transmitter TH. TRIM and adiust it to the motor re-emits "Beep-Beep" tone
4. If the car can't be speed up, please check either voltage of the battery pack is too low or the temperature of ESC is too high
If the voltage of the battery pack is too low, please replace the battery pack. If the temperature of ESC is too high, please
check all connections. If not. please push the button EPA on our remote control.
5. If the car stops suddenly while in working state, please check the motor's connections, and the roadblock.
6. If the car runs in the opposite direction, which the transmitter is available, please swap two wire connections between the
ESC and the motor.

WARNING
This is Electronic Speed Controller (ESC) for car. High power system for RC model is very dangerous, so please read this
manual carefully. Since we can't control over the correct use, installation, application, or maintenance of our products, we've
no liability shall be assumed nor accepted for any damages, losses or costs resulting from the use of the product. Any claims
arising from the operating, failure of malfunctioning etc. will be denied. We assume no liability for personal injury,
consequential damages resulting from our product or our workmanship.